[. . . ] The safety glasses and the face shield should conform with the requirements of AS/NZS 1336. WARNING: It is an employer's responsibility to enforce the use of safety eye protection equipment by the tool operators and by other persons in the immediate working area. Wear hearing protection to protect your ears against exhaust noise and head protection. Do not operate when under the influence of alcohol, drugs or the like. [. . . ] When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). Stop screw-driving operations immediately if you notice something wrong or out of the ordinary with the tool. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. ⷠUse only pneumatic tool oil specified in this manual. ⷠNever connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. ⷠDo not attempt to keep the trigger contact element depressed with tape or wire. ⷠAlways check contact element as instructed in this manual. Screws may be driven accidentally if the safety mechanism is not working correctly. Proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. When adjusting driving depth, always lock the trigger and disconnect the air hose. When adjusting driving depth, always lock the trigger and disconnect the air hose. This driver is equipped with an adjuster for adjusting screw driving depth. When using the hook, or changing its position, always lock the trigger, and disconnect the air hose. ⷠIf hook becomes unfastened and the driver drops, driver may operate by mistake, and lead to injury. Use an air hose as large and as short as possible to assure continuous, efficient screw-driving operation. cAUTION: · Low air output of the compressor, or a long or smaller diameter air hose in relation to the screw-driving frequency may cause a decrease in the driving capability of the tool. This driver is equipped with a switcher to enable selection of mode for optimum driving according to the material of the workpiece. set to mode positions shown in "Switching Mode Chart" below for optimum use. Thoroughly turn the knob until it clicks to a halt properly at either position (1) or (2). [. . . ] (2) With the trigger held down, each time the contact arm is pressed against the workpiece, a screw will be driven in continuously. When replacing bit, always lock trigger, disconnect air hose, and remove all loaded screws. Replace bit in clean surroundings to prevent dust and dirt from getting onto internal components. - The top cap spacer is removable , but please leave it on the driver. [. . . ]